mr
.
steam
®
chromasteam
™
Installation and Operating Instructions
11.
Hold fixture up against the ceiling and push clips
through housing slot. To lock clip in place push flat
portion against the side of the fixture using a flat
head screwdriver (fig. 6).
12.
Install the LED cluster into the wedge base in the
fixture.
13.
Install the fixture lens flush with the ceiling. (fig. 7)
14.
Apply a fillet of silicone around the edge of the
fixture lens where it meets the ceiling to ensure it is
sealed from moisture.
IMPORTANT
NOTE:
In areas where excessive ceiling
vibration can occur, we suggest using a
1
⁄
4
-
14
x
1
⁄
2
"
pan head sheet metal screw to lock the spring clip
against the housing. Drive the screw through the hole
provided in the spring clip and into the housing slot.
OPERATION
1.
Ensure the wall switch is left in the ON position.
2.
The nine color modes in order are:
a. Bright White f. Green
b. Blue/Green g. Red
c. Violet
h. Chameleon
(slow automatic cycle)
d. Blue
i. Party Mode
(fast automatic cycle)
e. Yellow
3.
To cycle through the color choices turn the light off
for 1 to 2 seconds using the CHROMA button on your
eTEMPO/PLUS control as shown. When the light is
turned back on the next color will illuminate.
Continue turning the light on and off till you select
the desired light to fit your mood.
NOTE:
The ChromaSteam lights can be turned ON/OFF
from the eTEMPO/PLUS control even if the steam
generator is not ON.
4.
If multiple lights are installed with one wall switch
they can be synchronized. Remove all the LED
clusters except one. Turn the switch ON and
note the color. Remove that cluster and install the
next. Turn the switch ON/OFF until the second
cluster matches the first. Remove the second
cluster and repeat the process for all the clusters
used. Reinstall all the clusters when completed and
they will be synchronized.
Ensure power is turned off at the
breaker before installing LED cluster. Hot Swapping LED
clusters could render them inoperable.
Please contact Mr.Steam Technical Support
at 1-800-STEAM for replacement LED clusters,
part number
104119
.
120 VAC
G
N
L
Field Supplied Wiring
BLACK WHITE GROUND
BLUE BLUE
WIRING BOX
WALL SWITCH
(Field Supplied)
Steambath Generator
Steambath Control Board
CHROMA
CHROMA
CAUTION
!
Wiring Diagram
Chroma button
3
Apply Silicone
around the lens
where it meets
the Ceiling
S
IL
IC
O
N
E
Figure 5
Figure 6
Figure 7