Mr. Coffee BVMC-JWX3-073, Инструкция по эксплуатации

Страница: 7 / 24

6
To Set the Clock:
1. Plug the power cord into a standard electrical outlet.The clock
will flash on the control panel to indicate that the time has not
been set yet.
2. Press and hold the hour “ ” or minute “ ” buttons until
you reach the current time. The AM or PM indicator will light
along the left side of the display (Figure 1).
The clock is now set!
NOTE: Pressing any button before setting the clock will cause the
clock to start keeping time from 12:00 a.m. You must set the clock
if you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply press and hold the
set delay “ ” button (Figure 2) and, set the brew time by
pressing the hour “ ” or minute “ ” buttons. The AM or
PM indicator will light at the clock display (Figure 3).
Within 35 seconds the display will change to the current time.
The Delay Brew Time is now set!
NOTE: To activate the delay brew cycle, see the Brewing Coffee
Later section.
To check the programmed time, press & hold the set delay
“ ” button. The display will show the time you have programmed the coffee
to brew. If you press the set delay “ ” button again or wait a few seconds, the
display will switch back.
SETTING THE CLOCK AND DELAY BREW TIME
Figure 1
Figure 2
Figure 3
BVMC-JWX3-073_14ECM1.indd 6 20/11/14 5:26 PM