LIMITED WARRANTY
The product you have purchased is guaranteed against defects in workmanship and materials for the period stated on the package. Warranties implied by
law are subject to the same time period limitation. Some states do not allow limitations on how long an implied warranty lasts, so this time limitation may
not apply to you. If the product fails due to a manufacturing defect during normal use, return the product and dated sales receipt to the store where pur-
chased for replacement OR send the product and the dated sales receipt to the address above.
Not Covered
– Batteries are not covered by this warranty.
Repair service, adjustment and calibration due to misuse, abuse or negligence are not covered by this warranty. Unauthorized service or modification to this
product or of any furnished components will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation,
set-up time, loss of use, postage, unauthorized service, or other products used in conjunction with, but are not supplied by, Wireless Environment.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
MOUNTING YOUR REMOTE CONTROL
Illustration 12
Determine placement for bracket and attach
to wall using two screws (enclosed) or tape
as shown in
Illustration 12
.
Illustration 13
Slide Remote into Bracket as Shown
in
Illustration 13
MOUNTING YOUR SPOTLIGHT TO WALL
Determine location for mounting Spotlight.
NOTE: FOR BEST PERFORMANCE, SPOT-
LIGHT SHOULD BE POSITIONED SO MO-
TION SENSOR IS ON TOP AND LIGHT IS
ON BOTTOM. The simplest way to attach
your Spotlight to a tree or wall is to drive the
large screw through the center of the mounting
base. First, loosen thumbscrew on mounting
base and separate the mounting base from the
rest of the light as shown in
Illustration 6
.
Drive large screw through center hole of the
mounting base as shown in
Illustration 7.
For a more secure attachment, first use the two
smaller screws as follows: Use template
(
above
) to mark two holes for anchors and/or
screws (included) as shown in
Illustration 8
.
NOTE: Spotlight can be rotated 360°, so screws
can be mounted in any position. We recom-
mend mounting the screws parallel to the
ground if mounting on a vertical surface. Make
sure that screws are precise distance from each
other as configured in template (2-1/8” apart).
Attach Mounting Base to screws as shown in
Illustration 9
. Slide Mounting Base down so
screws are securely held by track. If using an-
chors, use 3/16” drill bit to drill holes and insert
anchors. Drive screws into anchors so that
screw head protrudes 1/8” from surface (the
height of the screw head). If using screws only,
use 1/8” drill bit to drill holes and insert screws
so that screw head protrudes 1/8” from surface
To attach Spotlight to Mounting Base, align holes
then insert and tighten thumb screw (
Illustration
6
). To adjust Spotlight direction, loosen smaller
thumbscrew on Mounting Base and rotate Spotlight
to proper direction as shown in
Illustration 10
.
Tighten thumbscrew.
Loosen larger thumbscrew that connects Spotlight
Head to Mounting Base and adjust Spotlight Head
to proper direction as shown in
Illustration 11
.
Tighten thumbscrew.
Illustration 8
Illustration 9
Illustration 10
Illustration 11
2-1/8”
Use These Holes for Template
Screws
Tape Placement
Note:
Hold down On and Off buttons for
one second
to control light.
Illustration 6
Illustration 7
For More Installation and Use Advice, Along with More Wireless Lighting Products, go to www.mrbeams.com
