MQ Power WHISPERWATT DCA-70SSJU, Руководство по эксплуатации и запасным частям

Страница: 45 / 102

DCA-70SSJU SERIES — OPERATION AND PARTS MANUAL (STD)— REV. #5 (06/03/03) — PAGE 45
1
DCA-70SSJU SERIES — GENERATOR START-UP PROCEDURE (AUTO MODE)
Before connecting this
generator to any
building’s electrical
system, a licensed
electrician must install
an isolation (transfer)
switch
. Serious
injury
or
death
may result without this
transfer switch.
DANGER:
28. Perform steps 20 through 22 in the
Before Starting
section (pages 44) as outlined in the Manual Starting
Procedure .
29. Set the engine speed switch (Figure 69) to the “ HIGH ”
position.
31. Continue to follow the steps outlined in the “
Manual
Start-up” procedure (start at step 11, page 42).
Figure 69. Engine Speed Switch (High)
When running the generator in the “ AUTO “
mode, remember the generator can start up
at any time without warning.
NEVER attempt
to perform any maintenance when the
generator is in the auto mode.
WARNING:
When connecting the generator to a
isolation (transfer) switch,
ALWAYS have
power applied to the generator's internal
battery charger. This will ensure that the
engine will not fail due to a dead battery.
CAUTION:
Figure 70. Off/Manual Auto Switch (AUTO)
30. Place the Off/Manual/Auto switch (Figure 70) in the
“ AUTO “ position .
NOTE
When the generator is set in the
“
AUTO ” mode, the generator will
automically start
in the event of
comercial power falling below a
prescribed level by means of a
contact closure that is generated
automatically by a transfer switch.
The Engine Speed Switch must be set
to the “ HIGH ” position when running in the
Auto-Start
mode. Failing to set the switch
in the proper position can result in damage
to your generator when it turns on.
CAUTION: