MQ Multiquip MVC82VH, Руководство по эксплуатации и запасным частям

Страница: 24 / 74

PAGE 24 —MVC82VH/VHW PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #2 (06/03/16)
REPLACING THE V-BELT
Remove the upper and lower belt covers. Engage an
offset wrench (13 mm) or the like to vibrator pulley (lower)
fastening bolt. Engage waste cloth or the like at midway
of V-belt on the left side and while pulling it back strongly,
rotate the offset wrench clockwise so that the V-belt will
come off.
REINSTALLING THE V-BELT
Engage V-belt to lower vibrator pulley and push the V-belt
to left side of upper clutch and, in the same manner as in
removal, rotate offset wrench clockwise so that the V-belt
goes back on.
CHECKING CLUTCH
Check the clutch simultaneously with V-belt checking. With
belt removed, visually check outer drum of the clutch for
seizure and "V" groove for wear or damage. Clean the "V"
groove as necessary. Wear of lining or shoe should be
checked regularly. If the shoe is worn, power transmission
becomes deficient and slipping will result.
SPARK ARRESTER CLEANING
Clean the spark arrester every 6 months or 100 hours.
1. Remove the 4 mm screw (3) from the exhaust deflector,
then remove the deflector. See (Figure 21).
2. Remove the 5 mm screw (4) from the muffler protector,
then remove the muffler protector.
3. Remove the 4 mm screw from the spark arrestor, then
remove the spark arrester.
WARNING
NEVER attempt to check the V-belt with the engine
running. Severe injury can occur if your hand (Figure 7)
gets caught between the V-belt and the clutch. Always
use safety gloves.
MAINTENANCE
Figure 21. Spark Arrester Removal
4. Carefully remove carbon deposits from the spark
arrester screen (Figure 22) with a wire brush.
Figure 22. Cleaning The Spark Arrester
5. If the spark arrester is damaged and has breaks or
holes, replace with a new one.
6. Reinstall the spark arrester and muffler protector in
reverse order of disassembly.
PLATE COMPACTOR STORAGE
For storage of the plate compactor for over 30 days, the
following is required:
„
Drain the fuel tank completely or add STA-BIL to the fuel.
„
Run the engine until the fuel is completely consumed.
„ Completely drain the oil from the engine crankcase
and follow procedures described in the HONDA engine
Owner's Manual for engine storage.
„ Completely drain the compactor's hydraulic oil from the
vibrating case.
„ Clean entire plate compactor, especially the bottom plate
removing all dirt and foreign matter.
„ Cover plate compactor and engine with plastic covering
or equivalent and store in a clean, dry place.
SPARK
ARRESTER
DEFLECTOR
MUFFLER
PROTECTOR
5MM SCREW (4)
4MM SCREW (3)
4MM SCREW (1)
SPARK
ARRESTER
SCREEN
WIRE
BRUSH