MQ Multiquip Mikasa MTX60SF, Руководство по эксплуатации и запасным частям

Страница: 17 / 58

MTX60SF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (09/15/16) — PAGE 17
MAINTENANCE
DAILY
„
Thoroughly remove dirt and oil from the engine and
control area.
„ Clean or replace the air cleaner elements as necessary.
Check and retighten all fasteners as necessary.
„ Check the spring box and bellows for oil leaks. Repair
or replace as needed.
EVERY 50 HOURS
„
Remove and clean the spark plug, then adjust the spark
gap to 0.024~0.028 inch (0.6~0.7 mm).
EVERY 80 TO 100 HOURS
„
Remove the air cleaner cover. Loosen and remove
the 2 screws that hold the cover to the air cleaner
assembly. If the primary element (Figure 11) is dirty,
wash it with gasoline or kerosene. Then dip it in engine
oil (SAE10W-30) and wring the element so that 25 to 30
cc of engine oil remains on the element.
Figure 11. Air Cleaner Primary Element
EVERY 200 HOURS
„ Remove the oil drain plug on foot housing (Figure 12) and
drain the oil. Refill with approximately 1.4 pint (650 cc)
of 10W-30 SE, SF or higher grade motor oil. Oil should
be midway in sight glass. Break in oil should be changed
after first 50 hours.
Figure 12. Oil Drain Plug
PRIMARY
ELEMENT
SIGHT GLASS
OIL DRAIN PLUG
OIL FILL PLUG
EVERY 6 MONTHS
„
Clean the inside of the fuel tank with solvent.
„
Inspect and clean fuel strainer (Figure 13). Replace
strainer if necessary.
Figure 13. Fuel Strainer
EVERY 2 YEARS
„
Replace the fuel line every 2 years even if there is no
visible damage.
LONG TERM STORAGE
„
Slide the throttle lever to the
STOP
position.
„ Drain any fuel including in the fuel hose.
„
Replace lubrication oil and apply grease to lubrication
points.
„
Cover the air intake on the air cleaner and the exhaust
outlet on the muffler.
„
Store unit indoors covered with plastic sheet in moisture
free and dust free location out of direct sunlight.
MTX60SF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (03/01/13) — PAGE 17
MAINTENANCE
DAILY
Thoroughly remove dirt and oil from the engine and
control area.
Clean or replace the air cleaner elements as necessary.
Check and retighten all fasteners as necessary.
Check the spring box and bellows for oil leaks. Repair
or replace as needed.
EVERY 50 HOURS
EVERY 6 MONTHS
Clean the inside of the fuel tank with solvent.
Inspect and clean fuel strainer (Figure 13). Replace
strainer if necessary.
Figure 13. Fuel Strainer
EVERY 2 YEARS
Replace the fuel line every 2 years even if there is no
visible damage.
LONG TERM STORAGE
Slide the throttle lever to the
STOP
position.
Drain any fuel including in the fuel hose.
Replace lubrication oil and apply grease to lubrication
points.
Cover the air intake on the air cleaner and the exhaust
outlet on the m uffle r.
Store unit indoors covered with plastic sheet in moisture
free and dust free location out of direct sunlight.
FUEL FILTER
Remove and clean the spark plug, then adjust the spark
gap to 0.024~0.028 inch (0.6~0.7 mm).
EVERY 80 TO 100 HOURS
Remove the air cleaner cover. Loosen and remove
the 2 screws that hold the cover to the air cleaner
assembly. If the primary element (Figure 11) is dirty,
wash it with gasoline or kerosene. Then dip it in engine
oil (SAE10W-30) and wring the element so that 25 to 30
cc of engine oil remains on the element.
Figure 11. Air Cleaner Primary Element
EVERY 200 HOURS
Remove the oil drain plug on foot housing (Figure 12) and
drain the oil. Refill with approximately 1.4 pint (650 cc)
PRIMARY
ELEMENT
of 10W-30 SE, SF or higher grade motor oil. Oil should
be midway in sight glass. Break in oil should be changed
after first 50 hour s.
Figure 12. Oil Drain Plug
SIGHT GLASS
OIL DRAIN PLUG
OIL FILL PLUG