MQ Multiquip DCA20SPXU2, Руководство по эксплуатации и запасным частям

Страница: 20 / 74

PAGE 20 — DCA20SPXU2D 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/25/11)
LCD DISPLAY/GENERATOR CONTROL BOX
The defi nitions below describe the monitoring parameters
of the Digital Control Panel Display(Figure 6).
Figure 6. LCD Display
1. VOLT — Indicates the phase to phase reading at the
output terminals.
2. AMP — Indicates the current flowing to the load
connected at the output terminals.
3. PH — Indicates the voltage phase.
4. Hz — Indicates output frequency of the generator.
5. OIL —
During normal operation this gauge should read
between 35 ~65 psi. (241~448 kPa). When starting the
generator the oil pressure may read a little higher, but
after the engine warms up the oil pressure should return
to the correct pressure range.
6.
FUEL
— Indicates the percent of fuel remaining in the
fuel tank.
7. TEMP — During normal operation this gauge be should read
between 167°~203°F (75° ~95°C).
8.
BATT
— When the engine is running this value should
be greater than 13 VDC.
Located behind the generator control panel is the Generator
Control Box. This box contains some of the necessary
electronic components required to make the generator
function.
The Control Box is equipped with the following major
components:

Over-Current Relay

Automatic Voltage Regulator (AVR)

Starter Relay

Current Transformer

Voltage Selector Switch

Main Circuit Breaker
NOTICE
Via the internet, go to www. basler.com, for more detail
Digital Control Panel operating instructions.