EV2632-R-00A – 3A CHARGER, 3A BOOST DISCHARGE, ALL-IN-ONE
EV2632-R-00A Rev. 1.1
www.MonolithicPower.com
5
10/8/2015
MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2015 MPS. All Rights Reserved.
QUICK START GUIDE
This board is designed for the MP2632, a stand-alone switch-mode battery charge management and
system power path management device with integrated reverse directional boost from BATT to SYS.
The board’ layout accommodates most commonly-used capacitors. The default function of this board is
preset at charge mode, and the charge full voltage is preset to 4.35V for a 1-cell Li-Ion battery.
Charge Mode Setting
1. Input Current Limit
An input current limit can be set slightly below the input source’s maximum current rating. When the
input current hits this limit, the charge current will decrease to keep the input current constant at the
limit value to initially power the system. R
ILIM
—the resistor connected to the ILIM pin—programs this
limit. To set the input current limit at 2.7A, use a R
ILIM
of 14.7k
Ω
.
ILIM
ILIM
40(k )
I
(A)
R
(k )
(1)
2. Charge-Full
Voltage
To set the charge-full voltage, leave the VB pin floating for 4.2V, connect VB to L for 4.35V and
connect VB to H for 4.45V.
3. Charge
Current
The charge current can be programmed via both RS1 and R
ISET
. With given RS1=10m
Ω
, determine
the charge current using the following formula:
CHG
ISET
1500
I
(A)
R
(k ) RS1(mA)
(2)
For example, for a charge current of 3A, use a 49.9k
Ω
R
ISET
.
Boost Mode
1. System-Output-Current
Limit
Set the system-output-current limit in boost mode for the EV2632 to operate like a standard USB
charger. Set the output current limit as the following equation:
OLIM
OLIM
1500
I
(A)
R
(k ) RS1(m )
(3)
For the other detailed description on the operation of the MP2632, please refer to the datasheet.