MPM MWP-13M, Руководство пользователя, Страница: 11 / 28

11
GB
20.
Lock bolt
21.
Lock bolt knurled nut
22.
Fan head tilt lock knurled bolt
23.
Clamping screw
24.
ON/OFF/SPEED switch
25.
Run timer setting switch, range: 1 to 7 h
26.
Fan speed indicator lights
27.
Timer setting indicator lamps
28.
Remote controller
29.
Clamping screw
30.
Nut
PREPARING YOUR APPLIANCE
CAUTION! The fan must be placed on a stable, flat and dry surface! Do not place the fan near stoves and other
sources of heat.
1.
Remove all packaging parts, including plastic film, filling materials, and cardboard boxes.
2.
Check that all parts and accessories are in the product packaging.
CAUTION! Assemble the product completely before the first use.
ASSEMBLY
1.
Slide the pedestal tube (5) in the pedestal base (4).
2.
Place the pedestal weight (3) and the round washer (2) underneath the pedestal base (4).
3.
Thread in the L-shaped clamping bolt (1) clockwise to tighten the pedestal tube (5) to the
pedestal base (4) and the pedestal weight (2).
4.
Mount the motor (11) on the moving pedestal tube (7) with the square groove in the motor
handle (10) aligned with the bottom hole in the moving pedestal tube (7), as shown in Fig. 1.
5.
Insert the clamping bolt (20) in the square hole below. The square piece of the bolt must
engage the matching hole in the motor handle.
6.
Set the fan head tilt angle with the knurled bolt (22) and the clamping bolt (23).
7.
Tighten the knurled nut (21) on the knurled bolt (20).
8.
Install the rear fan grille (14) on the motor housing with the four bolts (13). The rear fan grille
should have the handle (18) on the top, with the handle closer to the motor housing.
9.
Mount and secure the fan propeller (16) on the motor shaft with the clamping bolt (15), which
must engage the threaded hole on the flat of the motor shaft.
10.
Mount the front fan griller (17) by engaging the hook (19) in the tab of the rear fan grille (14).
Make sure that the bolt holes in the front and rear fan grilles are aligned.
11.
Engage all hooks.
12.
Secure the front and rear fan grilles together with the bolts (29) and nuts (30).
13.
Attach the control panel to the moving pedestal tube with the bolt (9). The control panel
must be below the fan grille and with the button (25) downward.
USING THE FAN
CAUTION! Make sure that the fan stands on a firm, flat and dry surface before powering on.
1.
Plug the fan to the mains. Make sure that the mains voltage matches the nameplate ratings.
2.
Power on the fan with the button (24) (Fig. 2). A beep will sound. Pressing the button (24) re-
peatedly cycles through low, medium and high fan speed; the next press of the button with