11
GB
1.
Humidifier base
2.
Control panel
a.
POWER ON/OFF switch
b.
Humidifying intensity selector
button MIST
c.
TIMER button
d.
Humidity level/sleep mode selector
button CONSTANT HUMIDITY/SLEEP
MODE
e.
LED display
3.
Ultrasound transducer
4.
Essential oil reservoir
5.
Water level sensor
6.
5 l water tank
7.
Water filler plug
8.
Ceramic filter
9.
Water tank handle
10.
Outlet lid
11.
Air filter
12.
Filter cover
13.
Remote control
BEFORE FIRST USE
1.
Unpack the device, and remove all stickers, filling materials and transport locks. Inspect the
device carefully for any damage which may have occurred in transport. Consult the seller
when in doubt.
2.
Clean the device as instructed in Section CLEANING AND MAINTENANCE.
3.
Verify that the parameters of your power mains match the nameplate ratings.
4.
Place the device on a firm, dry, stable, flat and level surface. The humidifier can be operated
only in vertical position.
5.
Install a CR2025 battery in the remote control (see Section CLEANING AND MAINTENANCE).
ATTENTION! The battery is not included with MNP-04.
FILLING THE WATER TANK
ATTENTION! Always switch off the device and disconnect it from the mains before filling the water tank.
1.
Remove the outlet lid (10) from the water tank (6).
2.
Detach the water tank (6) from the base (1) using the water tank handle (9) and turn it bottom
up. Remove the water filler plug (7) in the bottom of the tank.
3.
Pour up to 5 litres of cold (preferably demineralised)
water in the tank (fig. 1), with water temperature not
exceeding 40°C. Replace and close the plug (7).
4.
Turn the tank and attach it to the base (1). Once the tank
is attached, the two bars on the base enclosure must be
aligned with the two bars on the tank enclosure.
ATTENTION! Before attaching the tank to the base, make sure
that the ceramic filter (8) is installed on the ultrasound transducer (3). The filter softens the water, extending
service life of the device.
5.
Replace the outlet lid (10) on the tank (6).
fig. 1
