2 INTRODUCTION
2.1 ABOUT THIS MANUAL
This Reference, the MXCS Technical Reference Manual and the MXCS BIOS User Manual provide information
for handling and configuring the MXCS 1548-P1. Be sure to read these manuals before attempting to use the
MXCS, and keep the manuals close at hand for reference during operation.
This reference is written
for advanced technical personnel
responsible for integrating the MXCS 1548-P1 into
their systems.
While the Tech Ref Manual and the BIOS User Manual contain deeper information about the MXCS mainboard,
contains this Reference an overview about the whole server unit, including the assembled sub modules.
2.2 SAFETY PRECAUTIONS AND HANDLING
For personal safety and safe operation of the MXCS 1548-P1, follow all safety procedures described here and
in other sections of the manual.
●
Remove power from the system before installing (or removing) the MXCS 1548-P1, to prevent the possibility
of personal injury (electrical shock) and / or damage to the product.
●
Handle the product carefully; i.e. dropping or mishandling the MXCS 1548-P1 can cause damage to
assemblies and components.
●
Do not expose the equipment to moisture.
2.3 ELECTROSTATIC DISCHARGE (ESD) PROTECTION
Various electrical components within the product are sensitive to static and electrostatic discharge. Even a small
static discharge can be sufficient to destroy or degrade a component's operation!
Do not touch any electronic components in an open MXCS 1548-P1 housing.
Handle and mount DIMM modules, PCIe and PCIe/104 cards, mSATA or other add-on modules and also cables
to internal connectors only in an ESD protected environment.
2.4 EQUIPMENT SAFETY
Great care is taken by MPL AG that all its products are thoroughly and rigorously tested before leaving the
factory to ensure that they are fully operational and conform to specification. However, no matter how reliable a
product, there is always the remote possibility that a defect may occur.
The occurrence of a defect on this device may, under certain conditions, cause a defect to occur in adjoining
and/or connected equipment. It is the customers responsibility to protect such equipment when installing this
device. MPL AG accepts no responsibility whatsoever for such defects, however caused.
©2017 by MPL AG
5
MEH-10180-501 Rev. A
High-Tech • Made in Switzerland
MXCS 1548-P1
Operators Quick Reference
