2
Issue 01.2021
Do not open the rooflight while driving. The rooflight must be locked down before
traveling.
Do not open the rooflight in strong wind or rain .
Close the rooflight during rain and snowfall.
Installation
Please clean the frames carefully before mounting the
sealant.
Follow the instructions of the sealant manufacturer.
Separate the inner and outer frames and fit the outer frame
to the outside of the roof aperture onto a bed of sealant.
Hinge side in the direction of travel!
Place over the screw holes on the inside of the frame, the 8
fixing brackets; four in each corner, four in the centre of each
side. Secure with screws, stop as soon as the brackets start to
distort.
Max. Torque 0.5 Nm.
Remove the small tabs on the corner bracket before installing
the inner frame.
To fit the inner frame, gently pull out the pointed ends of the
cover profiles to release them and reveal the fixing points.
Turn off the power supply in the vehicle before
proceeding with the connection of the LED lighting.
Connect the supplied connection cable to the power supply
installed in the vehicle.
Connect the Polyswitch cable of the inner frame to the power
supply of the vehicle. Then place the inner frame in the centre
of the cutout.
Version 1: Timber support under the roof lining
Offer up the inner frame into the outer frame.
Use the four small
holes to fix the inner frame with standard screws into the timber
support.
Version 2: Inner lining made of plywood / polyester layer
Offer up the inner frame into the outer frame and mark drill
holes (large screw hole).
Pre-drill the screw holes and screw the inner frame tight with
the supplied plastic screws.
Fix the connector from the inner frame with the connector from
the side panel before inserting the side cover.
Refit the inner frame covers by locating the securing lugs
and keeping the covers parallel against the roof whilst sliding
them carefully onto the frame, ‘clicking’ back into position,
without distorting.
Permanent ventilation
The rooflight is supplied without permanent ventilation. If required, the rooflight can be
converted to a permanently ventilated rooflight. To achieve this you must remove and shorten
the fitted seal. In addition, fit the supplied, self-adhesive seal profile.
Without free-air-flow
Rubber seal 160 cm
Äußerer Kanal, ringsum
With free-air-flow 75cm²
Rubber seal shortened
to 90 cm
Hinge side, outer seal channel
Self-adhesive seal profile
rear, inner seal channel
With free-air-flow 150 cm²
Rubber seal shortened
to 34 cm
Hinge side, outer seal channel
Self-adhesive seal profile rear,
inner seal channel
Var.1
Var. 2
