MPC F1775i, Руководство пользователя, Страница: 8 / 26

MPC Computers 2005 © MAS001984-00
8
Note: A certified power supply cord must be used with this equipment. The
relevant national installation and/or equipment regulations need to be
considered. Use a cord that meets the following criteria:
•
Monitor side must have IEC320-type female, straight plug
•
Main side must have IEC320-type male, straight plug
•
Wire type must be UL/CSA certified, 18 AWG X 3C
Video Cable
The video cable that comes with your monitor has identical connectors at
each end. To connect the video cable between the monitor and your
computer’s video port, complete the following steps:
1 Plug the video cable's 15-pin connector into the computer's video port,
taking care not to bend any pins on the connector.
2 Plug the other end of the video cable into the VGA connection on the
monitor (See (2) in Figure 2.), taking care not to bend any pins on the
connector.
3 Tighten the two screws on each end of the video cable with your fingers to
secure the connection.
Caution: Over-tightening this connection can damage the monitor
cable or your computer’s video card.
ADJUSTING THE VIEWING POSITION
•
For optimal viewing, look at the full face of the monitor, and then adjust
the monitor’s angle and height to your own preference.
•
Hold the base so the monitor does not fall when you change the monitor’s
angle.
•
The monitor’s tilt angle may be adjusted from -2
°
to 25
°
(1).
•
The monitor’s left/right pivot position may be ad/- 35
°
(2).
•
The monitor’s height may be adjusted up to 524mm (3).
Caution: To avoid breaking the wires inside the cable, do not bend the
signal cable excessively.