4
iFocus needs to be connected to MOZA Air 2 for firmware upgrade.
a. Connect the iFocus to MOZA Air 2 via Multi-CAN cable.
b. Long press the power button for 3 seconds in power off status until the white
indicator lights up.
c. Follow MOZA Air 2 firmware instruction to upgrade the firmware.
d. Restart the iFocus and MOZA Air 2 after the upgrade is complete.
2.Charging
Charge the iFocus with USB-C. Then LED light turns blue. When fully charging, the
light goes off automatically.
When connecting iFocus to MOZA Air2 with Multi-CAN cable, Air 2 can charge
iFocus.
3.Turn on and turn off
Long press the power button for 1 second, and the light turns green. The motor
turns on.
Long press the power button for 1 second and red light blinks twice. The motor
turns off.
4.Route Calibration
Mark the total distance of the lens focus ring by route calibration before using the
iFocus to avoid rotating the motor over the route of lens focus ring.
The motor remembers your last calibration and does not need to be re-calibrated
every time it is turned on unless you change the motor position or remount it after
the motor has been shut off.
The operations of route calibration are as follows:
a. Enter the Air 2 menu, and select Advanced>iFocus>Turn off to turn off the
iFocus motor.
b. Manually rotate the lens to the start point, then select Advanced>iFocus>Start
point to confirm the start point.
Firmware Upgrade
Specifications
Note: The iFocus motor can be turned on by selecting Advanced > IFocus>
turn on during calibration. Note that if the start and end points are not calibrated,
the calibration is invalid.
Note: Turn down the sensibility level if the iFocus rotates too fast, and turn the
level up it if the iFocus rotates too slowly.
c. Manually rotate the lens to the end point, then select Advanced>iFocus>End
point to confirm the end point. The iFocus motor will start automatically.
5.Control iFocus movement by Air 2
a. Enter the Air 2 menu, Gimbal Set>Operations>Wheel>Function>Focus-1 or
Focus-2 to select the wheel to control the follow focus. You could also press the
Mode button on the Air 2 until the wheel mode on the screen turns to Foucs-1
or Focus-2 mode.
b. Rotate the wheel to control the motion of iFocus
6.iFocus Control Sensibility Settings
Enter the Air 2 menu, and select Gimbal Set>Operations>Wheel>Sensi to adjust
the control sensibility.
Weight(battery excluded) 198g
Dimensions
115*65*30mm
Operating Voltage
7.
4
V
Battery Capacity
600mAh
Bluetooth
Support
Charging Port
USB-C
Note
：
This product must be used with USB line with ferrite.
