- 4 -
Reset Button—
Depress the
Reset
button continuously for 5 sec. to
load factory defaults.
The reset button is used to load factory defaults. Depress the reset
button for five seconds using a pointed object, such as a straightened
paper clip. Release the reset button when the Ready LED stops blinking.
LED Indicators
Name
Color Function
PWR 1,
PWR 2
Green Power is being supplied to the power input.
Off
The power cable is not connected.
Ready
Green
Steady on: Power is on and unit is functioning
normally.
Blinking: Unit is responding to DSU’s locate
function.
Red
Steady on: Power is on and the unit is booting up.
Blinking: IP conflict, DHCP, or BOOTP server did not
respond properly, or a relay output occurred.
Off
Power is off.
P1, P2
Green Serial port is transmitting data.
Amber Serial port is receiving data.
Off
Data is not being transmitted.
Ethernet
Green Indicates a 100 Mbps Ethernet connection.
Amber Indicates a 10 Mbps Ethernet connection.
Off
Ethernet cable is disconnected.
WLAN
Green
Steady On: Unit is properly connected with the AP.
Blinking: Unit is trying to connect to the AP.
Red
Indicates an IP conflict, or DHCP or BOOTP server is
not responding properly.
RF
Green
3 LEDs = the signal strength is between 67% and
100%.
2 LEDs = the signal strength is between 34% and
66%.
1 LED = the signal strength is between 0% and
33%.
Hardware Installation Procedure
STEP 1:
After unpacking the unit, connect the power supply to the
unit. Make sure the adapter is connected to an earthed
socket.
STEP 2:
Use an Ethernet cable to connect the unit to the network.
STEP 3:
Connect your device to the desired port on the unit.
STEP 4:
Place or mount the unit. The unit may be placed on a
horizontal surface such as a desktop, or mounted on the
wall.
Содержание MGate W5108 series
Страница 3: ...3 MGate W5108 MGate W5208...