MD-219 Hardware Manual
Hardware Connection Description
3-4
Panel Mounting
The MD-219 Series comes with 14 optional clamp
mounts that allow for installation onto a wall (where
space has been cut out to accommodate the rest of
the hardware) or into computing stations where a
flush mount is desired.
The maximum thickness
of the surface to which the display can be
clamped is 11 mm.
For a secure mounting, all 14
clamps must be used. The clamp arms are fastened
into slots on all four sides of the MD-219. Use the
short M4 SUS (stainless) screws to fasten the clamp
arms to the MD-219 mounting slots, as shown in the
magnified inset in the diagram just below. Next, use
the clamps to fasten the display to its mounting
point; please note the torque values shown in the
figure inset below.
