- 5 -
To remove the EDS from the DIN-Rail, simply reverse Steps 1 and 2
above.
Wall Mounting (optional)
For some applications, you will find it convenient to mount the
EDS-G205A-4PoE on the wall, as shown in the following figures.
STEP 1:
Remove the
aluminum DIN-Rail
attachment plate from the
EDS-G205A-4PoE’s rear
panel, and then attach the
wall mount plates as shown
in the diagram at the right.
STEP 2:
Mounting the EDS-G205A-4PoE on the wall requires 4
screws. Use the switch, with wall mount plates
attached, as a guide to mark the correct locations of
the 4 screws. The heads of the screws should be less
than 6.0 mm in diameter, and the shafts should be
less than 3.5 mm in diameter, as shown in the figure
at the right.
NOTE
Before tightening the screws into the wall, make sure the screw
head and shank size are suitable by inserting the screw into one
of the keyhole-shaped apertures of the wall mounting plates.
Do not screw the screws in completely—leave about 2 mm to
allow room for sliding the wall mount panel between the wall and
the screws
STEP 3:
Once the screws are fixed on the wall, insert the four screw heads through
the large parts of the keyhole-shaped apertures, and then slide the EDS
downwards, as indicated. Tighten the four screws for added stability.
