- 11 -
Wiring the Redundant Power Inputs
The EDS device includes both high-voltage and low-voltage products.
For the low-voltage (LV models) products, there are two power inputs
for redundancy; for the high-voltage (HV models) products, there is
only one power input. Refer to the instructions and diagram below on
how to connect the wires to the terminal block connector on the
receptor.
STEP 1:
Insert the Positive/Negative
DC or Line/Neutral AC wires into the
V+/V- or L/N terminals, respectively.
STEP 2:
To keep the DC or AC wires
from pulling loose, use a small flat-
blade screwdriver to tighten the wire-
clamp screws on the front of the
terminal block connector.
STEP 3:
Insert the plastic terminal
block connector prongs into the
terminal block receptor, which is
located on the EDS devices’ right side.
Wiring the Digital Inputs
The EDS device has one set of digital input (DI). The DI consists of two
contacts of the 4-pin terminal block connector on the EDS's right-side
panel. Refer to the instructions and diagram below on how to connect
the wires to the terminal block connector on the receptor.
Содержание EDS-4008-2GT-2GS
Страница 5: ...5 EDS 4008 2MST T Models...