- 4 -
Installing the Driver for the CAN controller
After the driver for the CAN interface board has been installed, Windows
will automatically detect the new CAN controller.
Step 1: The Found New Hardware Wizard window will open to help
you install the driver. This window will offer to connect to the
Windows update site to search for a driver. Select No, not at
this time and then click Next to continue.
Step 2: Select Install the software automatically
(Recommended), and then click Next to continue.
Step 3: Windows will spend a few moments installing the CAN
controller driver.
Step 4: After all files have been copied to the system, the Completing
the Found New Hardware Wizard window will open to
indicate that it has finished installing the driver. Click Finish to
proceed with the rest of the installation.
Step 5: Repeat Steps 1 through 4 for each of the remaining controllers.
Step 6: The Found New Hardware balloon will reappear to inform
you that the hardware was installed successfully.
Specifications
Hardware
CAN Controller
NXP SJA1000
CAN Transceiver
PCA82C251
CAN Specification
CAN 2.0 A/B
Signal Support
CAN_H, CAN_L, GND
Board Interface
CP-602U-I: Universal PCI
CB-602I: PC/104-Plus bus module
CP602E-I: PCI Express x 1
Connectors
CP-602U-I/CP-602E-I: DB9 male
CB-602I: 20-pin box header
Ports
2
Transfer rate
1 Mbps
Termination Resistor
120 ohms (selected by jumper)
Max. Module Support 4 pcs
Optical Isolation
2 KV
Software
Operating Systems
Windows 2000, Windows XP/2003/Vista/2008
(x86 and x64), Windows 7
Library
Visual Basic, C/C++
Physical Characteristics
Dimensions
CP-602U-I: 120 x 80 mm ( 4.72 x 3.15 in)
CB-602I: 90 x 96 mm ( 3.54 x 3.78 in)
CP-602E-I: 120 x 80 mm ( 4.72 x 3.15 in)
Environment Limits
Humidity (Operating) 5 to 95% RH
