C320Turbo/PCIEL
Hardware Installation
2-4
C: Plug the DB25 (female) connector into the CPU Module.
WARNING
Do not use a 25-pin cable to connect the Intellio C320Turbo/PCIEL Control Board to the CPU Module when using
the power adapter as this will cause severe damage. (Power will come from the power adapter and from the
Intellio C320Turbo/PCIEL Control Board.)
D: Connect the power adapter to the CPU Module. Keep the CPU Module’s power switch in the OFF
position. If UART Modules are also required, keep the CPU Module powered OFF until all
necessary UART Modules are installed.
E: Install the power adapter to a power source (110V or 220V AC).
F: Replace the system cover.
Step 8: Connect the first UART Module to the CPU Module. Connect the second UART Module to the first one
if necessary and so on.
To securely connect the modules, a Connector Kit is included (metal plates and screws)
Step 9: After making sure that each component has been correctly installed, you are recommended to power
on the CPU Module first and then power on the PC system.
☞
Installation of the external CPU/UART modules is now complete. Continue to install
the software driver as explained in chapter 3.
Installing the Basic and Extensive Modules (Rackmount)
Step 7: Connect the Intellio C320Turbo/PCIEL Control Board to the Basic Module with the DB25 to DB25
cable as shown below.
If range extension or external power is required, please use the 10-pin cable that is included with
extension kit instead. There are two types installation: without power adapter and with power
