4
ATTACHMENT OF COLD AIR SELF-SUPPORTED DUCT:
Climate Pro X14/
X20/X26
Trim Ring
Cold Air Flange Kit
Flange
Screw (4)
Clamp
1. Take out the six (6) screws and remove the nozzle
adapter.
Screw (6)
Nozzle Adapter
2. Secure the metal adapter to the opening of the
upper front panel with the six (6) screws.
2. Attach the cold air flange to the adapter with the
four (4) screws
3. Pass the clamp through the cold air self-supported
duct and fasten it temporarily.
4. Hold the duct approximately 1 foot away from the
end and increase the diameter as shown.
5. Place the duct over the flange and decrease the
diameter until the duct fits exactly over the flange.
Secure with the clamp.
6. Place the trim ring over the end of the duct.
Decrease the diameter
Increase the diameter
Cold Air Self-supported Duct
Nozzle Apapter Kit
Screw (6)
Metal Adapter
Metal Adapter
Cold Air Flange
Screw (4)
Metal Adapter
Screw (6)
Flange
Cold Air Self-supported Duct
Clamp
Trim Ring