Installation Guide
8
1) Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop
on the main PCB and into the Mini-Din Connector on the main PCB.
2) Pull the wire tie loop tight and cut off the excess.
3) Connect the Power Harness to the mating connector on the Video Monitor.
4) Connect the power harness to the vehicle’s electrical system through an In-Line 5-Ampere fuse by
tapping into an accessory hot line.
5) Verify all functions of the System before final mounting of the finished assembly.
Note
: A second VCP or other A/V Component can be connected to the video monitor system using a
second Source Component Harness (purchased separately, part number: 8010730). This second
harness would plug into the second Mini-Din connector on the main PCB as in steps 1 above.
A/V Source Definitions:
1= AV1 (right Mini-Din on main PCB)
MM701
1
2
Red RCA (Audio Right)
White RCA (Audio Left)
Yellow RCA (Video)
Mini-Din Connectors
Power
Connector 4 Pin
IR LED:
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Window on the Face of the VCP.
“Y” Adapter
for use with
Non-Stereo
Installations
Accessory
Harness
item #2
Accessory
Harness
item #2
Power Harness
item #3
Dome
Light
Red: +12VDC
(Accessory Cir.)
Black: Ground
ANT.IN
RF OUT
OUT
FUSE
DC IN
Red: +12VDC
Accessory Ckt.
(Install 5A
Inline Fuse)
Audio Output
for FM Mod.
