BF-Series (BF060, BF080 & BF120 models) Operation Instructions
Corporate Headquarters:
1080 North 11th Street, San Jose, CA 95112 Phone: (408) 292-2214 Fax: (408) 292-2733
www.mountztorque.com
Page 4
BF-Series Standard Models & Soft Stop Models
These models feature an adjustable RPM setting on the tool. The
RPM settings can be adjusted to the preset increments as shown
label (see image on the right).
These models also feature a selectable Soft Start mode (from 0.2,
0.4 & 0.6 seconds).
How to Adjust Speed Setting
1. Press and hold the Speed button for 2 seconds.
2. Two LEDs will display colors that show the current speed
selection of the brushless screwdriver.
3. Position the F/R slide switch in R or F to increase (+) or decrease
(-) RPM setting of the tool Slide switch to "R" position to increase
speed. Slide switch to "F" to decrease speed. Then press the
Speed button until the target speed is selected. The two LEDs
will display colors that show the current speed selection (see
table below for reference)
Note!
The RPM settings can only be
adjusted to the preset increments as shown on the label
(see chart below).
4. By starting the screwdriver, the selected speed is saved
automatically.
Program Lock Key
The Program Lock Key protects from incidental or operator tampering of the
programmable settings on the side of select BF-Series models* (V3 models
only). To adjust the settings the Program Lock Key must be is plugged into
the STC40 & FT-30D Mini Transformer.
Note!
The program Key
cannot
be used with BF-Series Standard Plus
Models, Soft Stop Plus Models & Angle & Auto Reverse Models.
Speed Selection
To adjust the settings the Program Lock Key
must be is plugged into the STC40 & FT-30D
Mini Transformer.
