2 of 16
WARNING
•
Be sure to read this entire manual thoroughly and you fully understand all the
instructions and warning before attempting to begin your installation.
•
Sufficient expertise is required for installing of this product. Be sure to subcontract the
installation to a qualified person. Ensure special attention to safety is paid during
installation. MOUNTUP mount is not liable for any damage or injury caused by
mishandling or improper installation, or by installing anything other than the specified
product.Your statutory rights, (if any) are not affected.
If the safety precautions are not observed or the product is used incorrectly, it may
result to serious injury or damage to your wall and TV.This instruction manual shows
the correct handling of the product and important precautions necessary to prevent
accident. Be sure to read this manual thoroughly and use the product correctly.Keep
the manual available for future reference.
•
Ensure your hands and fingers stay clear from the adjustable moving mechanics at
the back of the bracket. This is to avoid your fingers getting trapped. Please supervise
children when this product is in use.
•
This product is supplied with small parts for installation. For your children’s safety
please keep out of reach of children at all times.
•
This product should only be installed by someone who has a basic knowledge of
building construction,installations and fully understands these instructions.
•
Made sure that the supporting surface will safely support the combined load of the
mount,the display and all attached hardware and components.
•
This wall bracket will supporting displays(LCD,Plasma).The maximum load capacity
is 143 pounds.
•
If mouting to a wall of wood stud construction,be sure that mounting bolt are anchored
to the center of the studs,When installing the TV mount on a concrete wall, the wall
must be at least 8”(203mm) thick with a minimum compressive strength from 2500 to
3000 psi(17.2 to 20.7 MPa),the concrete wall must meet ASTM C39.When installing
the TV mount on a cinder block wall, the cinder blocks must meet ASTM C216
specifications and have a minimum nominal width of 8”(203mm). Be sure to mount in
a solid part of the block,generally 1”(25 mm) minimum from the side of the block.
Do not drill into mortar joints! If plaster/drywall is thicker than 16mm, custom fasteners
must be supplied by the installer.
•
Always have someone assist you to lift and position your equipment.
•
Tighten screws and bolts firmly,but do not over tighten.Over tightening can damage the
items and greatly reduce their ability to hold.Please refer to suggested torque values
where applicable in these instructions.
•
•
Screws must be tightly secured,but do not overtighten any screws(especially the four
Hex Bolt Screws M8x63.5mm) or damage can occur and product may fail.