9
IF
GREEN Light blinking
: Car battery voltage is too low. Press the “BOOST”
button on black control box. Once GREEN indicator is on, crank the engine within
30 seconds.
IF
No Light is on, no Beep sounds
: Damaged battery or no battery. Make sure
all connection is correct, then press the “BOOST” button. Once GREEN indicator
is on, crank the engine within 30 seconds.
Note: The “BOOST” button on the control box of jumper cable is designed to be “Hard-
to-touch” to prevent from
mis-operation
. Trigger this button to manual override the
jump starter following above operation instructions.
6. Once the vehicle is running, remove the jumper cable from the battery box and
disconnect red and black clamps to the vehicle battery terminals within 30 seconds.
RUNNING/CHARGING USB DEVICES
1. Plug the supplied USB cables KTIHD4903-P4/P5 or the device USB cable into the
Type C port
or
USB Output Ports
on the battery box.
2. Plug appropriate connector of the USB cable into your power -hungry device.
3. Press the
Main Power Button
to charge your devices.
Note: Time required to achieve a full charge varies based on the size of the battery in the
mobile device.
Note: The supplied USB cables are for charging purpose only; Not for data transfer.
RUNNING/CHARGING 12V DC APPLIANCES
1. Plug the
12V DC Adapter
(
KTIHD4903-P6
)
to
15V 10A output port
on the battery
box.
2. Make sure that the appliance to be powered is turned off and it’s power requirement
DOES NOT exceed 10A.
3. Plug the male plug of your 12V appliance into the Cigarette lighter socket of the 12V
DC Adapter.
4. Press
Main Power Button
and turn on the appliance.
USING THE LED WORK LIGHT
1. Press the
Main Power Button
and hold for 3 seconds to turn on the light.
2. Press the button slightly to activate the three modes of LED light (strobe, SOS, flash
light).
Note: Make sure the light is turned off when the unit is being recharged or stored.
TROUBLE SHOOTING
Unit will not charge
Make sure the
Main Power Button
has been pressed to turn the unit on.
Check connection to the Recharging Port(Type C) on the battery box.
