8
!
Glue the long control horn into the elevator. The elevator horn faces down.
!
Glue the two aileron control horns to the ailerons, facing down.
!
Install the servo control horns on the servos. The aileron servo needs a double sided horn and the
elevator servo needs a single horn. The aileron servo needs two micro control horn adjusters
mounted towards the servo. It is easiest to install them now. See the photo further down showing
the aileron servo.
!
Insert two servos into the servo opening by wrapping the servos in tape, pressing them into the
openings the CAREFULLY gluing them in place with thick CA.
!
Tape the pushrod tube to the top of the top carbon fiber tube such that the front of the pushrod
tube is even with the back of the fuselage. Tape the tube at the front and right in front of the
vertical stabilizer.
!
Bend a Z bend into the 1/32” music wire. Slide the other end of the wire into the front opening of
the pushrod tube.
!
Cut a piece of 1/32” music wire 2.5” long. Make a 90 degree bend 1/4" from one end.
!
Slip a piece of 3/4” long heat shrink tubing over the tail end of the elevator pushrod. Slide the
long end of the L bend wire into the heat shrink and place the short end into the outermost hole of
the horn. Flip the end of the pushrod over the horn then carefully shrink the heat shrink tubing.
!
Adjust the length of the push rods by sliding the L bend wire in or out of the pushrod until the
elevator is level with the carbon fiber tube. Carefully secure the wires in position with a drop of
thin CA into the heatshrink. Ensure that the locking arm is in place – opposite the L bend.
!
Cut two pieces of 1/32 music wire 2 3/4” long. Make a Z bend in one end and put the Z bend in
the outermost hole of the aileron horn. Put the other end in the aileron servo micro adjuster.
