Repeat steps 1 & 2 to fit Snap Lock to hole
C.
Place one of the screws and cover buttons into hole
B
. Using Allen
Key rotate screw in a clockwise direction until screw is tight.
4
3
Repeat steps 1 & 2 to fit Snap Lock to hole
B.
Place one of the screws and cover buttons into hole
C
. Using Allen
Key rotate screw in a clockwise direction until screw is tight.
6
5
Fitting Carrycot to Frame
When placing Carrycot, ensure
front end of Carr ycot is
vertically above footplate within
shaded zone shown.
Push Snap Locks firmly into position, so they butt up to joints indicated
in the diagram above for your model.
5
OPEN POSITION
CLOSED POSITION
Removing Carrycot from Frame
Open the 2 Snap Locks and lift Carrycot off buggy frame.
“CLICK”
•
Follow instructions for your model
STAGE 3
Ensure Snap Locks are rotated so
screw holes are on top.
1
2
Fitting Sliding Plate to Carrycot
•
Position Sliding Plate on the other side of Carrycot.
•
Sliding Plate uses holes
A
&
C
in side of Carrycot, hole
B
is not
required.
•
There are 4 screw holes in Sliding Plate. Using diagrams below locate
which two holes are required for your model stroller.
Align hole
1
of Sliding Plate with hole
A
of Carrycot. Align hole
2
of
Sliding Plate with hole
C
of Carrycot.
Place screws into holes
1
&
2
. Using Allen Key rotate screws in a
clockwise direction until both screws are tight.
8
7
Align hole
1
of Sliding Plate with hole
A
of Carrycot. Align hole
3
of
Sliding Plate with hole
C
of Carrycot.
Place screws into holes
1
&
3
. Using Allen Key rotate screws in a
clockwise direction until both screws are tight.
WARNING
Using the Allen Key, check that the Snap Locks and Sliding
Plate are firmly tightened, and they will not separate from
Carrycot.
10
9
Place Carrycot between
side tube and centre bar of
stroller.
Locate centre bar lug.
Slide the Sliding Plate on Carrycot down the
centre bar of frame until groove in Sliding Plate locks
onto centre bar lug at point
Z
.
3
Open both Snap Locks by lifting levers up.
4
X
Y
sunhood joint
X
Y
TERRAIN
- Place Snap Lock
X
directly above sunhood joint.
URBAN -
Place Snap Lock
Y
directly above tube joint.
Close the Snap Locks down flat, making sure your hear the lock “click”
indicating they are fully locked.
To fit a second Double carrycot onto Double or Triple stroller, follow
instructions for stages 2 & 3 again.
6
WARNING
•
Check Carrycot is horizontal and is located correctly
onto stroller frame. Refer back to diagrams for your
model to ensure positioning of Snap Locks and Sliding
Plate are correct.
•
Check Snap Locks are closed and firmly attached to
frame and Carrycot will not tip or fall.
•
Do not use Carrycot if you are unable to secure. In this
case, contact store where stroller was purchased or
distributor for your country, for more help.
•
Always remove Carrycot(s) before collapsing buggy!
tube joint
