These instructions are for the Double Carrycot, which fits the following
model strollers:
Terrain Double - T2204
Terrain Triple - T3204
Urban Double - U2204
DOUBLE CARRYCOT INSTRUCTIONS
IMPORTANT, KEEP FOR FUTURE REFERENCE
ADCis1/3/04gen
1
WARNING
•
Do not use this Carrycot until you have read and
understood the instructions!
•
Carrycot is suitable for newborn baby to 6 months, or
until baby can sit up unaided.
•
Before placing baby into position check that the
Carrycot is secure and will not tip or fall.
•
Baby must not be in the Carrycot when it is being
fastened or removed from the stroller frame.
•
The depth from the top of the mattress to the top of
the side of the Carrycot at, or at any position within,
300mm/11.8in from the harness attachment points,
should not be reduced to less than 140mm/5.5in when
the mattress is in position. Mattresses purchased
separately should conform to BS1877 part 10.
•
Do not use accessories not designed for your stroller
as they might be unsafe.
•
Do not use the Carrycot to transport children in a
motor vehicle.
•
Never leave your child unattended.
•
The Sunhood and Seat(s) need to be removed from stroller
before fitting Carrycot(s). To fit one Carrycot, remove one seat.
To fit twoCarrycots, remove two seats.
•
Store items removed in a dry safe place.
Removing Seat
STAGE 1
Pull support wire out of
Sunhood joint
A.
This
operation is child proof and
therefore requires a degree of
force. To assist in pulling
support wire out, push
against buggy frame with
other hand
B.
Repeat step (1) on other
side.
Unfasten sunhood fabric
from stroller frame and seat
near handle bar.
3
1
Removing Sunhood
(all three models)
2
A
B
Sunhood Joint
• Carrycot(s) can be fitted onto stroller frame onto left and/or right side(s)
of stroller, but not in middle of triple stroller.
• If fitting two Carrycots remove left and right seats. If fitting one Carrycot
decide before removing seats which side of stroller you want Carrycot
fitted to.
• Left and right are determined when standing behind stroller in pushing
position.
Unfasten seat from frame along side tubes and centre bar.
On Urban model, unfasten strap underneath seat at point
A
.
Push seat forward, then slide fabric off seat support wire.
Remove seat support wire from stroller frame at
B,C,D &E.
1
2
3
4
STAGE 2
•
To position Carrycot onto right side of stroller, put Snap Locks onto
right side of Carrycot and Sliding Plate onto left. To position Carrycot
onto left side of stroller, put Snap Locks onto left side of Carrycot and
Sliding Plate onto right.
•
Left and right are determinded when standing at base of Carrycot,
looking into Carrycot Sunhood.
1
Place one of the Snap Locks
over hole
A
. Make sure it is aligned
correctly with the hole in Carrycot.
Using Allen key, rotate screw
in Snap Lock in a clockwise
direction until screw is tight. Snap
Lock is firmly attached to Carrycot,
but can still rotate.
2
Fitting Snap Locks to Carrycot
2 x Cover
Buttons
