Moulinex IM1130E0, Руководство пользователя

Страница: 11 / 36

PROBLEM CAUSES SOLUTIONS
Water drips from
the holes in the
soleplate.
The chosen temperature is too low
and does not allow the formation of
steam.
You are using steam while the iron is
not hot enough.
You are using the Shot of Steam
button
*
too often.
There is too much steam selected.
You have stored the iron
horizontally, without emptying it and
without setting it to .
Set the thermostat knob in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of
the button.
Reduce the steam rate.
Always store your iron on its heel. Adjust the
steam button on dry position.
Brown streaks
come through the
soleplate and stain
the linen.
You are using chemical descaling
agents.
You are not using the right type of
water.
Fabric fibres have accumulated in
the holes of the soleplate and are
burning.
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
Do not add any descaling agents to the
water in the water tank.
Perform a self-cleaning operation
*
and
consult the section "What type of water to
use?".
Perform the self-cleaning operation
*
and
clean the soleplate with a damp sponge.
Vacuum the holes of the soleplate from time
to time.
Make sure that your laundry is rinsed
sufficiently so as to remove any deposits of
soap or chemical products on new clothes.
The soleplate is
dirty or brown and
can stain the linen.
You are ironing with an
inappropriate setting (temperature
too high).
Clean the soleplate with a non-metallic
sponge. Select the appropriate setting.
You are using starch. Always spray starch onto the reverse side of
the fabric.
There is little or no
steam.
The water tank is empty.
Your iron has a build-up of scale.
Your iron has been used dry for too
long.
Fill it.
Carry out a self-clean
*
.
Carry out a self-clean
*
.
The soleplate is
scratched or
damaged.
You have placed your iron flat on a
metallic rest-plate or ironed over a
zip.
Always set your iron on its heel.
Steam or water
comes out from the
iron as you finish
filling the tank.
The steam control is not set to .
The water tank is overfilled.
Check that the steam control is set to .
Never overfill the water tank. Empty out the
excess.
The spray
*
does
not spray.
There is not enough water in the
water tank.
Fill up the water tank.
If there is a problem
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
‹ Leave it at a local civic waste collection point.
If you have any problem or queries, please contact our Customer Relations team first for expert help and
advice:
Helpline:
0845 602 1454 - UK / (01) 4610390 - Ireland
Or consult our Website: www.moulinex.co.uk
EN
11
*
depending on model