P a g e
|
23
User Guidelines
– Flosense 4.0 Manifold 16-06-2020
Version 002
4.3.
Refitting Sensor
In order to replace the sensors as described below, make sure to remove the cables first.
1. Locate the sensor you wish to replace or
refit.
2. Pull out the small locking pin at the side
of the piping.
3. Once the pin is pulled out far enough,
the sensor is no longer locked in place.
4. Remove the sensor by pulling it out
5. Make sure that the sensor is removed
correctly. Remove anything from the
pipes, like the O ring which commonly
gets stuck.
6. Replace sensor if needed, and remount
the O ring if it fell off in step 5.
