MOTU 896HD, Руководство пользователя

Страница: 41 / 76

M O T U F I R E W I R E A U D I O C O N S O L E
41
Programmable Meters
This option lets you choose which bank you wish
to monitor with the eight programmable meters on
the MOTU 896HD front panel. Your choices are:
Analog Out, ADAT In or ADAT Out. You can also
adjust this setting by repeatedly pushing the
VOLUME knob on the 896HD front panel.
AES/EBU Meters
This option lets you choose to monitor either AES/
EBU input or output with the programmable AES/
EBU meters on the MOTU 896HD front panel. You
can also adjust this setting by repeatedly pushing
the VOLUME knob on the 896HD front panel.
Clip Hold Time
The Clip Hold Time option controls how long the
top red LED remains illuminated after clipping
occurs (see Figure 5-2 below).
Figure 5-2: The Clip Hold Time option.
Peak Hold Time
The 896HD front-panel level meters support
standard peak/hold metering, where the LED for
the highest level recently measured on the channel
remains illuminated for a brief period of time while
the rest of the LEDs below it remain fully dynamic.
The
Peak Hold Time controls how long the peak-
hold LED remain illuminated before going dark
again.
Disable Interface option
Check this option to temporarily take an interface
off line. Doing so frees up FireWire bandwidth for
other devices without turning off the disabled
896HD.
Word Out
The Word Out menu appears when the 896HD is
operating at a 2x sample rate (88.2 or 96kHz) or 4x
sample rate (176.4 or 192kHz). This menu lets you
set the word clock output either to match the
current sample rate (
System Clock ) or force it to the
corresponding 1x rate (either 44.1 or 48kHz). For
example, if the 896HD were operating at 176.4kHz,
choosing the
Force 44.1/48kHz option would
produce word clock output at 44.1kHz.
The ‘Clip Hold Time’ option controls
how long this LED remains illuminated.
This LED lights up momentarily.