Motovox MVS10, Руководство пользователя

Страница: 7 / 19

FUELING
STARTING
PACKAGE CONTENTS
IINITIAL SETUP
The MVs10 uses a two-stroke engine. Always run
the engine using a fuel mixture of gasoline with the
proper amount of 2-cycle engine oil.
Please read instructions below before fueling.
1. Mix fuel (minimum 87 octane) and 2-cycle engine
oil in a separate container. Use a good quality 40:1
ratio 2-cycle oil. Make sure the fuel is well mixed by
shaking the container before filling the fuel tank on
the scooter. Be sure and mark the container visibly that it contains oil/gas mix.
2. Make sure that the engine is not running.
3. Open the fuel cap slowly, so that possible pressure build-up can be released.
4. Wipe off the fuel cap area to make sure that it is free of dirt and debris.
5. Pour pre-mixed Gas/Oil mixture into the fuel tank being careful not to overfill.
6. After fueling, replace the fuel cap and tighten.
7. clean any spilled fuel off the tank and engine.
Never try to mix the oil and gas in the MVs10 Fuel tank,
always mix it well in a separate fuel container first.
Move at least 10 feet away from where you filled up the tank to get
away from spills and fumes.
1. Set the choke to the ON (up) position.
2. Turn the key to the ON position.
3. Press the fuel primer bulb several times until you see fuel in the bulb.
4. Holding the left hand grip, pull the starter briskly. Note: Do not allow it to snap
back, instead, let it recoil slowly.
3. You may want to give it a little throttle by gently squeezing the thumb throttle.
4. It may be necessary to pull start the motor several times the first time you start it.
5. Once the engine has started and run for 20 seconds, move the choke lever down
to the OFF position.
6. Let the engine warm up for a minute before riding.
Your Motovox MVs10 comes with the following items in the shipping carton.
When opening the carton for the fisrt time, be sure you have the following items:
1. MVs10 Stand-up Scooter
2. Tool set
3. Owners Manual
Please read and follow these instructions carefully!
1. Carefully remove the MVs10 from the carton.
2. To unfold the MVs10, begin by pressing down on the FOLDING LEVER with one
hand (see below) while gently pulling up on the steering tube with the other.
3. Fully extend the steering tube to its upright position until you feel the mechanism
lock into place.
4. When you first take the MVs10 out of the box, the HANDLEBARS are not clamped to
the steering tube in order to save space for shipping. Place the handlebar clamp over
the steering tube, taking care to position them as straight as possible. Then, using the
allen wrench found in your tool kit, firmly tighten the tension bolts in the clamp.
Do not pull cables!
GETTING STARTED MIXING FUEL
9 8 OPERATING CONTROLS
Fuel Tank
Folding steering tube
Handlebar clamp
Locking folding lever
Handlebar assembly
TROUBLE
?
DO NOT RETURN TO STORE
contact us!
888-488-MOTO (6686)
or email info@motovox.com