Beginning the Service……
Performing a Standard Fluid Exchange:
1.
Connect the power cord to 12 V. battery.(red+ black-).
2.
Pour the power steering “flush” fluid into the clean fluid tank.
3. Verify that the cap is installed on the waste fluid tank.
4. Start the vehicles engine.
5. Insert the service hose “wand” into the vehicles power steering fluid reservoir.
(fill level is controlled by the position of the short hose of the wand).
6. Turn the service switch to “run” position.
7. When the clean tank is emptly, turn the service switch to “off”.
8. Turn the vehicles steering wheel fully right and left 3 times.
9. Turn off vehicle.
10. Pour Conditioner into “new” fluid tank and fill the tank with steering fluid
recommended for vehicle. (Do not exceed 2000 ml level on tank).
11. Check level in waste tank to verify that there is enough ‘empty’ space to receive
the amount of fluid in clean tank. If necessary, empty waste tank and replace cap
before continuing.
12. Repeat steps 4 thru 9.
13. Check fluid level in vehicles reservoir, top off if necessary.
14.
Empty waste fluid tank
The MotorVac SteerClean Power Steering Fluid Exchange machine is designed to
flush all of the old fluid along with any contaminates out of the entire power
steering system, and replace with clean power steering fluid.
Here is the step-by-step procedure for a complete fluid exchange using the
MotorVac SteerClean system.
