June 15, 2005
6815854H01-A
3-74
Theory of Operation:
Controller Section
The multiplexer allows TX modulation audio to be routed from one of 3 possible sources: mobile
microphone (MIC_HI), AUX_MIC (audio sourced from the J2 rear accessory connector in motorcycle
configuration), or AUX_TX (audio from a VRS). The resulting audio source is then sent to a two-
stage, programmable gain/attenuation circuit comprised of U0201 and U0202. The gain is
accomplished via a programmable digital potentiometer in the amplifier circuit. This gain is
adjustable via CPS and is programmed in ±3 dB steps. After passing through an anti-aliasing filter,
audio is sent to the input of the CODEC (U0200) where it is digitized via its internal A/D converter.
The digital audio data is then sent via the SAP SSI bus to the DSP at the Patriot IC. As with speaker
data samples, the DSP reads the microphone audio samples and processes, pre-emphasizes,
filters, and adds signaling information to this data. As with the received trunking data, low-speed
transmit data is processed by the MCU and returned to the DSP. For secure messages, the digital
signal data can be passed to the secure module prior to DSP processing and modulation. The DSP
transfers the data to and from the secure module through the SAP SSI transmit (TXD) and receive
(RXD) lines.
Figure 3-49. XTL 1500 TX Signal Path
After the DSP has finished its processing, filtering, and signaling on the audio data samples, it then
sends this data to the modulation DAC (U0900) on the BBP SSI port, where it is converted to the
analog modulation signal. The data is clocked over to the modulation DAC at a 2.4 MHz bit rate, with
a frame sync (representing the transmit data sample rate) of 48 kHz. Both of these clocks are
generated by the Urchin IC (U0901).
The modulation DAC audio output signal is sent to a switched capacitor low-pass filter (FL0900) that
performs anti-aliasing filtering. The filter output is sent through a multiplexer switch, U0902, and
finally on to the FGU/LV Frac-N synthesizer for modulation of the RF carrier signal.
Patriot
U100
SPI
SAP
BBP
CODEC
U0200
URCHIN Clock
IC
U0901
Modulation DAC
U0900
Gain/Attenuation
Stages (U0201, U202)
Low Pass Filter
FL0900
MODIN
MIC_HI
SCKA
SRDA
SCKA
SCKB
STDB
SC2B
S PI_SC
SPI_MOSI
SPI_MISO
MCLK
DT
FSR
TG
2.4MHz
MOD Data
48kHz
SCK
STD
SFS
FM OUT
Input
Output
(To LV FRACN)
(J0401-4)
512kHz
TX Data
8kHz
48kHz
2.4MHz
MAEPF-27890-O
Содержание XTL 1500
