Motorola ROKR E1, Руководство по обслуживанию

Страница: 23 / 50

6809495A42-O July 08, 2005 23
Level 1 and 2 Service Manual Disassembly
Removing and Replacing the Rear Housing
1. Remove the battery cover, battery, as described in the procedures.
2. Using a small screwdriver, gently pry off the left and right rubber screw covers
that conceal the top two screws on the rear housing.
3. Using a Torx
®
driver with a T-6 bit, remove the 6 screws from the rear housing
(see Figure 8).
4. Carefully separate the rear housing from the front housing by starting at the
top and lifting the rear housing up and away from the front housing to remove.
5. To replace, insert the bottom of the rear housing into the front housing and
gently press together.
6. Insert and torque the 6 screws to 29 Ncm (2.6 in. pounds).
7. Replace the screw covers and rotate to match the curve of the rear housing and
press firmly into place.
8. Replace the SIM, battery, and battery cover as described in the procedures.
Removing and Replacing the Transceiver PC Board
1. Remove the battery cover, battery, SIM, and rear housing as described in the
procedures.
2. Insert the flat end of the disassembly tool between the front housing and the
transceiver PC board as shown in Figure 9.
041101o
Figure 8. Removing and Replacing the Rear Housing
G
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent ESD and component damage.
Screw Locations
Rear Housing
Lift Rear Housing
Up and Off Front
Housing