Motorola RG2400, Руководство пользователя

Страница: 25 / 50

25
S
ETTING THE
R
EMOTE
C
ONTROL
ID
Your NSP uses the following table when programming your remote control ID to work with each TV in your
household. You may use it, too.
To program the remote control ID:
Note:
Valid single-digit codes are 0, 1, 2 (and 3, with 3-stream models).
If you entered an invalid sequence or a 20-second lapse in button presses occurs, the LED turns off and the
remote control returns to standard operation.
If you correctly entered the single-digit code, the LED flashes on and off and then remains off.
Once you have set the remote control ID, write 0, 1, 2, or 3 on labels and place these labels on the TV and the
remote to help you identify the TV and the remote to which it is assigned. Your Network Service Provider may
have already done this.
Repeat this procedure for each remote control.
P
ROGRAMMING THE
TV C
ODE
Your Network Service Provider programs each remote control to work with one TV by way of a TV code. The TV
Code is a specific code for each brand and model of TV. When a TV code is set, the remote control is ready to
operate the TV. The TV codes can be programmed manually, or they can be scanned. Each of the methods is
described below.
Remote Control ID Operates TV Mode
0 Local TV1--TV in same room as RG. Remote is set to operate in IR mode. IR
1 Remote TV1--TV in a different room than the RG. UHF
2 TV2 (remote TV). UHF
3 TV3 (3-stream models only). UHF
SRC-300A SRC-200
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid.
3. Press the A key. The remote is now in programming
mode.
4. Enter the single-digit remote control ID from the table
on page 25.
1. Press and continue to hold the A button until the LED at
the top of the remote flashes rapidly.
2. Enter the following three-digit sequence: 7-8-9. The
remote is now in programming mode.
3. Enter the single-digit remote control ID from the table
on page 25.