Motorola RG2400, Руководство пользователя

Страница: 21 / 50

21
A
DVANCED
U
SE
You will need the information in this section if you want to change the default settings that were set up by your
NSP or reprogram your remote control because it is not working correctly.
Note:
Your NSP programs your RG2400 and remote control when your system is first connected. The NSP also
programs the same Gateway ID (this is the ID of your RG2400) into all the remote controls in your home. If there
is more than one RG2400 in your home, your NSP programs the Gateway ID into each remote control that com-
municates with a specific RG2400.
C
HANGING OR
P
ROGRAMMING
S
ETTINGS
By using the remote control, the RG2400 front-panel buttons, and on-screen menus, you can perform the follow-
ing tasks.
D
ETERMINE THE REMOTE CONTROL
O
PERATING
M
ODE
(SRC-300A
ONLY
)
1.
Press the LED key for three seconds until the LED flashes.
2.
Press the INFO key. The LED stops blinking at this point and stays on solid.
3.
Press and release the D key. When the D key is released, the LED immediately turns off.
4.
Watch the LED.
The Operating Mode is indicated by a blink sequence. A short burst of flickering blinks indicates a '0' (SRC-
200 Compatibility Mode) while a single blink indicates a '1' (SRC-300A Native Mode.) There is a 1-second
pause before the LED turns on.
Once the LED sequence has completed, the SRC-300A returns to normal mode operation.
S
ET THE REMOTE CONTROL
O
PERATING
M
ODE
(SRC-300A
ONLY
)
The SRC-300A remote control operates older RG models as well as newer models. To allow for this, the remote
can be set to operate in either SRC-200 Compatibility Mode or SRC-300A Native Mode. When in SRC-200
Compatibility Mode, the SRC-300A transmits IR/UHF messages that use the same format as the SRC-200
remote control (messages are 16-bits in length.) When in SRC-300A Native Mode, the SRC-300A transmits IR/
UHF messages using the 18-bit message format. The default operating mode is SRC-200 Compatibility mode.
To program the operating mode:
1.
Press and hold the LED key until it starts to blink.
■
Determine the remote control Operating Mode
■
Set the remote control Operating Mode
■
Determine the Gateway ID
■
Set the Gateway ID
■
Determine the Remote Control ID
■
Set the Remote Control ID
■
Program TV Code
■
Verify the TV RF channel
■
Set the Display Language
■
Set up Secondary Audio
■
Set the EADS (Emergency Alert Device Support) display