RFS7000 Series RF Switch:
Installation Guide
4
3
LED Codes
The RFS7010 RF Switch has four vertically-stacked LEDs on its front panel. Each of the switch’s
Gigabit Ethernet ports have two status LEDs. These LEDs display two colors (green & amber), and
three lit states (solid, blinking, and off). The following tables decode the combinations of LED colors
and states for the System Status LEDs and the Gigabit Ethernet LEDs.
3.1 System Status LEDs
3.1.1 Start Up / POST (Primary System or Redundant System)
System Status 1 LED
System Status 2 LED
Event
Off
Off
Power off
Green Blinking
Green Blinking
Power On Self Test (POST) running
Green Solid
Green Blinking
POST succeeded (Operating System Loading)
Green Solid
Off
POST succeeded (Normal Operation)
Amber Blinking
Off
POST Failure
Alternating Green Blinking
& Amber Blinking
Alternating Green Blinking
& Amber Blinking
Boot Up Error: Device has an invalid checksum
NOTE
During switch start up, the Temperature status LED will be lit Solid
Amber. This is normal behavior and does not indicate an error. At the
completion of start up the Temperature Status LED will switch to Solid
Green.
6\VWHP6WDWXV
)DQVWDWXV
7HPSHUDWXUHVWDWXV
6\VWHP6WDWXV
