Motorola RDX SERIES, Руководство пользователя

Страница: 42 / 180

English
39
P
R
OGRA
MMIN
G FEA
T
UR
ES
Code Charts” on page 64 to make sure you are
programming a valid value.
I am trying to enter the Programming Mode but the
radio would not do it.
• The radio may be locked using the CPS to
disallow Front Panel Programming. To re- enable,
use the CPS.
I programmed the wrong value when I was
programming. How can I erase or re-program the
value?
If you programmed the wrong value, you can either:
• ‘Roll-over’ the radio. The radio ‘roll-over’ each
time it reaches the maximum value allowed.
Keep increasing (short press the SB1 button)
or decreasing (short press the SB2 button) until
you get the desired value or,
• Turn OFF the radio and start over.
I just programmed the value I wanted. How do I exit
the Programming Mode?
You can either:
• Long press the PTT button twice to exit if
you’re in the Programming Mode or,
• Long press the PTT button once if you are
already in the ‘Idle’ Programming mode.
I am done programming the features in this channel.
How do I program another channel?
• Short press the PTT button several times until
you hear “Channel Number”. Switch channel by
rotating the Channel Selector Knob. If you wish to
save the changes, make sure you are in the ‘Idle’
Programming Mode before switching the
channel, otherwise you will lose the changes
made.
PROGRAMMING VALUES EXAMPLES
Example of Programming a Frequency
Assuming current frequency value is set to Channel 1,
with the UHF default frequency set to ‘02’ (equivalent
to 464.5500 MHz), and you want to change it to
Frequency Number = ‘13’ (which is mapped to
461.1375 MHz), follow this sequence:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button to enter Frequency
Mode. The radio audible voice announces that
the current value is ‘2’.
MN002895A01_final.book Page 39 Thursday, January 5, 2017 10:51 AM