July, 2002
6880360B49-A
5
Installation
Mobile 1/4-Wave Antennas
4.
Install the mount to the outside roof thickness
per installation procedure given for vehicles
with single wall construction..
Mini-UHF Connector Installation
Use Motorola hand tool part #66-80388A26 (Refer to
Figure 12). A deluxe rachet type tool is available; order
part #66-80334B40.
Installation Instructions
1.
Slip ferrule and collar onto cable. Refer to
Figure 13.
2.
Prepare cable to strip dimensions per
Figure 14, which is also marked on the hand
tool.
3.
Insert stripped cable into plug body until con-
ductor is exposed (front end) and dielectric
bottoms inside body. Refer to Figure 13.
4.
Crimp center contact using proper crimp
section of tool. Refer to Figure 12 marked
"CENTER CONTACT."
5.
Push collar forward onto plug assembly. Fit
cable braid over the support sleeve of the con-
nector. Refer to Figure 13.
6.
Push ferrule over braid until flange butts
against connector body. Refer to Figure 13.
Using the correct crimp area of the tool, crimp
the ferrule close to the plug body. See
Figure 12, crimp location "C." Crimp ferrule a
second time close to the cable end.
7.
The protruding center conductor should be
trimmed flush with the end of the center contact.
Figure 10.
Roof Mount in Vehicle Without Dome Light
Figure 9.
Roof Mount in Vehicle With
Dome Light or Removable Headlining
Figure 11.
Typical Mount Location
