24
March 28, 2007
6809511A67-O
Disassembly
10.
Place the camera assembly back into the front housing. Connect the camera flex cable to
the daughter board. After connecting the camera flex, apply the conductive gasket as shown
below.
11.
Place water detect label in location shown.
12.
Replace the rear housing, SIM, battery, and battery cover as described in the procedures.
Figure 16. Camera Assembly Placement
Figure 17. Camera Assembly Removal
Apply conductive gasket as shown.
This section is
placed on camera
connector.
Align gasket to
edges of
connector.
Place the tape over the label on
the camera connector.
