•
Duplex Vol — sets the volume level for duplex ringtones.
•
Simplex Vol — sets the volume level for simplex ringtones.
•
Earpiece Vol — sets the volume level for the earpiece.
•
Speaker Vol — sets the volume level for the speaker.
•
Keypad Vol — sets the volume level for keypad tones.
NOTICE: If the display shows only one option Volume, you can adjust all of the above
settings at once. You have the option to change the settings individually when the
Volume Adj. Mode is set to Individual.
4 Press Right or Left Navigation key to change the value.
NOTICE: When the battery level is low it is not recommended to attach the 4 Ohm
speaker to the radio as it can cause reset or shutdown of the radio.
4.8.3
Language
This sub-menu allows you to change the language of the radio.
4.8.3.1
Setting Language
Prerequisites: The list of available languages is set by service provider.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup
→
Language.
3 Select desired language.
4.8.4
Data Setup
This menu item allows you to set up your radio to transmit and receive data from the external device.
To connect your radio accessory connector to the external device, use the PMLN5237 cable. The
external device must run an application complying with the TETRA standards.
NOTICE:
•
Data services are available only in TMO Mode.
•
Data services are blocked in TXI Mode.
•
When set to Voice Only, the built-in data modem is disabled to conserve battery power.
4.8.4.1
Setting Data Function
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup
→
Data Setup.
3 Select one of the following:
•
Voice Only — Your radio receives and transmits voice calls only.
6866588D06–RB
Chapter 4: Main Menu
76
Содержание MTP810Ex
