Motorola MN001433A01, Руководство по установке

Страница: 7 / 200

5
Englis
h
7. To avoid possible interference with blasting operations,
turn your radio OFF before entering an area where you
may be close to electrical blasting caps, in a “blasting
area” or in areas posted as “Turn OFF two-way radios”.
Obey all signs and instructions.
Operating Specifications
MTP6000 Car Kit Junction Box (PMLN6662)
Input voltage range: 10.8 DC to 16.6 VDC
Safety And General Information
A properly installed Car Kit minimizes service calls. When
mounting the components of the Car Kit, consider the
following factors:
• The mounting surface must have sufficient strength to
support the item being mounted to prevent it from
becoming loose over time.
• Do not attach components to any part of the vehicle that
is subject to excessive vibration.
• The proposed location of the item being mounted or
wires/cables attached must not interfere with driver/
passenger seating or leg space.
• Use the supplied mounting hardware.
• Ensure that the cables are not stretched, and not subject
to heat from the engine, transmission housing or heating
ducts.
• Crimp or tie together all the wires using a cable tie to
keep tidy.
• Ensure that screws are securely fastened on all
connectors.
• Do not run cables over sharp edges that may cause
excessive wear or chaffing of the cable insulation.
• Do not install components in locations where they may
cause interference to the operation of the vehicle's
controls.
MN001433A01.book Page 5 Sunday, March 29, 2015 1:18 AM