12
Getting Started
2.4
Registration (Pairing)
The Baby monitor is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1.
Press the
M
button of the parent unit and the menu bar will pop up.
2.
Press the
<
LEFT button or
>
RIGHT button until
is highlighted and
then press the
O
button so the
Add
/
Delete
menu will pop up.
3.
Press the
+
UP button or
-
DOWN button to select
Add
, and press the
O
button to confirm.
4.
cam 1
/
cam 2
/
cam 3
/
cam 4
will pop up, press the
+
UP button
or
-
DOWN button to select the desired Camera and press the
O
button to start searching for a camera unit. The green ON / OFF LED will
flash rapidly while searching.
5.
Press and hold the PAIR button underneath the baby unit until the parent
unit finds the camera, beeps and the video from the camera appears.
NOTE:
You can only register a new camera to a camera number that is not already
paired.
Paired camera numbers are indicated by a *, such as cam*1.
If the camera being paired was registered previously, it will lose the old
registration when it is paired again.
