Getting Started
11
ENGLISH
2.4
Registration (Pairing)
The Baby monitor is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1.
Press the
M
button of the parent unit and the menu bar will pop up.
2.
Press the
<
LEFT button or
>
RIGHT button until
is highlighted, and
the
/
/
/
menu will pop up.
3.
Press the
+
UP button or
-
DOWN button to select
, and press the
O
button to confirm.
4.
/
/
/
will pop up, press the
+
UP button or
-
DOWN button
to select the desired camera position and press the
O
button to start
searching for a camera unit. The green audio level LED will flash rapidly
while searching.
5.
Press the
O
button to confirm.
6.
Press and hold the PAIR button underneath the baby unit until the parent
unit finds the camera, beeps and the video from the camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current
Baby Unit again will overwrite the old registration.
2.5
View Video Through TV
Connect a suitable AV cable into the AV OUT socket on the side of the Parent
Unit and into the AV input of the TV. Press the
<
LEFT button or
>
RIGHT
button to select
on the Parent unit. Select the AV input on the TV menu until
the Baby monitor picture is visible. AV cable is an optional accessory, which is to
be purchased separately.
NOTE
You can also hear your baby in mono mode by connecting the 3.5mm plug
wired headset to the AV OUT socket.