Motorola LXN 500, Руководство по установке, настройке и эксплуатации

Страница: 56 / 66

MN003563A01-B
Vehicle Installation
56
Send Feedback
Figure 3-7
LXN 500 Installed Inside a Trunk of a Vehicle
To install the LXN 500:
1.
Connect the four brackets to the LXN 500 using the provided 4mm Allen screws. Torque the screws
to 60.7 inch-pounds (70 kg-cm).
2.
Ground the LXN 500 to the vehicle chassis (See Ground Polarity on page 52 ).
3.
Secure the LXN 500 to the mounting surface using four 1/4" self-drilling tap screws.
4.
Connect the antenna cables to the connectors on the back panel of the LXN 500 (See Figure 3-1 and
Figure 3-2 ).
5.
Connect the power cable to the PWR connector at the back panel of the LXN 500 (See Figure 3-4
and Figure 3-6 ).
IMPORTANT
To avoid possible shout down of the LXN 500 during engine cranking, a Power Protection and
Backup unit should be used (See
Installing the Optional Power Protection and Back-up Unit
on page 54 ).
Installing Antennas
Vehicle RF antennas must be installed external to the vehicle and in accordance with:
•
Requirements of the antenna manufacturer/supplier.
•
Instructions provided by the installation manual of other radio devices installed next to the LXN
500.
Tray
LXN 500
Tray Lip
Mounting Brackets
Ground Connection Point
Optional Power Protection and Back-up Unit
NOTE
The LXN 500 Mounting Bracket must be connected to the vehicle chassis through a low impedance
ground connection. Bolt the Mounting Bracket directly to the vehicle chassis or connect it to the vehicle
chassis by Ground wire or copper braided ground strap.