Motorola I903, Руководство пользователя

Страница: 33 / 44

Help 33
No ring tone
• The ringer may be off.
• The volume may need to be increased.
Caller ID does not work
• Check your subscription with your network operator.
• If you subscribe to high-speed internet service (Digital
Subscriber Line - DSL) through your telephone lines, you
must install a DSL filter between the telephone base and
the telephone wall jack. The filter will prevent noise and
caller ID problems caused by DSL interference. Please
contact your DSL service provider for more information
about DSL filters.
A phonebook entry cannot be stored
• The phonebook is full. Delete an entry to free memory.
No display
• Try recharging or replacing the rechargeable battery
pack.
• Reset the base. Unplug the unit's electrical, then plug it
back in.
• If the LED is not lit up, then try to unplug the unit's
electrical power, and then plug it back in.
If the handset/headset disconnects from the base
during a phone call
• Check that the power cord is connected properly into the
base.
• Check that the power adapter is connected properly into
the electrical outlet.
• Move the handset/headset closer to the base. It may be
out of range.
• Reset the base by unplugging the unit's electrical power.
Reset the handset by unplugging and re-plugging its
battery pack. Reset the headset by clicking into the reset
hole. Wait for around 15 seconds and re-plug the power
again. Allow up to one minute for the handset/headset to
synchronize with the registered base again.
Noise interference on your radio or television
• Your base or charger may be too close. Move it as far
away as possible.