Motorola HSN1006A, Инструкция по эксплуатации

Страница: 3 / 9

September, 2000 6881110C10-O
1
Speaker/Amplifier
Model HSN1006A
1. Description
1.1 The speaker/ampliÞer consists of a 6-watt
integrated circuit ampliÞer and a 2.0 ohm speaker,
enclosed in a rugged, weather -resistant housing.
The housing is designed to be mounted either
inside or outside (Please see the Window
Mounting Bracket Detail, Figure 1) of a schoolbus,
truck, emergency van, or other similar vehicle.
1.2 The speaker/ampliÞer is used in options for
Motorola XTVA, Vehicular Adapters, and other
similar products.
1.3 The speaker/ampliÞer includes a trunnion
bracket, hanger bracket, and wall mount bracket.
These brackets enable the speaker to be mounted
in a variety of different ways. Refer to Figure 1.
The trunnion bracket provides a large variety of
permanent mountings (dashboard and accessible
Þrewall areas) for the speaker, while permitting it
to be tilted or angled for best results.
The hanger bracket (already attached to the
speaker) by itself permits temporary mounting on
projections, such as automobile windows. In this
case, the speaker must be removed from its
trunnion bracket by loosening the two wing
screws.
The wall mount bracket can be used for permanent
mountings if the trunnion bracket is too large to Þt
in inaccessible areas. In this case, remove the
trunnion bracket and attach the speaker to the wall
mount bracket using the hanger bracket. Security
screws are included for optional use in place of
wing screws.
2. Installation
2.1 These tools are required for installation:
¥ Center punch
¥ Hammer
¥ Drill, 1/4" Chuck
¥ #22 Twist Drill (0.157") for self-tapping screws
¥ #38 Twist Drill (0.101") for self-tapping screws
¥ Nut Driver, 1/4"
¥ Nut Driver, 5/16"
2.2 Trunnion Bracket Installation Procedure (Refer to
Figure 1.)
Step 1. Remove the trunnion bracket by loosening the
two wing screws.
Step 2. Remove the three paper retainers and screws
from the trunnion bracket.
Step 3. Remove the wall mount bracket from its taped
position on the hanger bracket, and retain for
future use.
Step 4. Using the trunnion bracket as a template,
mark the location of the three desired
mounting holes.
Step 5. Centerpunch and drill a 0.157" diameter hole
at each location.
Step 6. Mount the trunnion bracket using the
supplied screws.
Step 7. Remount the speaker into the trunnion
bracket and retighten the two wing screws.
2.3 Wall Mount Bracket Installation Procedure (Refer
to Figure 1.)
Step 1. Remove the wall mount bracket from its taped
position on the hanger bracket.
Step 2. Remove the trunnion bracket and trunnion
wing screws, and retain for future use.
Step 3. Remove the two paper retainers and screws
from the wall mount bracket.
Step 4. Determine the location for the installation.
Step 5. Using the bracket as a template, mark the
location for the screws.
Step 6. Centerpunch and drill a 0.101" diameter hole
at both locations.
Step 7. Mount the wall mount bracket to the surface
with the supplied screws.