Motorola HPD 1000, Руководство пользователя

Страница: 16 / 34

10
Status Applet and Features
Power Management
There are four available ways to control the ON/OFF cycle for HPD:
• Computer Communication Cable (USB or Ethernet or Both)
• Front Button Press
• Ignition
• Battery Voltage Level
Note: ONLY Igniton and Battery Voltage are required conditions for
the other two to work.
Assuming Ignition is attached to the car's ignition and the Car's
ignition is in the
ON position, and the power cable is attached to a
fully charged Battery, then the following is true:
1 Your Modem will turn ON and stay ON when a
Communication Cable is connected between a powered-
up computer (includes standby or sleep modes) with the
HPD modem.
2 Your modem will turn ON and stay ON with the press of
the Power Button even If there is no Communication Cable
attached or the computer is OFF (or in hibernation mode).
3 If your Modem was turned on via a Power Button Press
(without an active Communication Cable attached), it can
be turned
OFF via a subsequent Button Press.
Note: This occurs ONLY after your modem has initialized and
showing a flashing green LED, which is about 6
seconds after the initial button press.
4 If an active Communication Cable is attached after your
modem was turned on via a button Press (without an
active Communication Cable attached), it will remain
ON
from any subsequent button presses.
Note: Your modem will only turn OFF either by removing the
communication cable or turning the computer off.
96C67_Text.book Page 10 Monday, February 20, 2006 5:19 PM