Motorola hmac9100, Быстрый старт

Страница: 4 / 10

4
Installing Your Wireless Signal Repeater
Your repeater can either be mounted on a wall or sit on a level surface.
Warning: When mounting near a window, drilling too close to the glass could break the glass and possibly cause it to
shatter. The window extends deeper into the frame than can be seen; therefore, ensure your screw is beyond the
glass before drilling.
1
Using the holes on the drilling template found later in this guide, mark the position of the holes to be drilled.
For drywall or other composite surfaces use a 7/32" drill bit. Drill a hole for each of the mounting screws and
insert a plastic wall anchor into each hole.
For other solid surfaces, use a 1/16" drill bit. Drill a pilot hole for each of the
mounting screws.
2
Using the screws provided, secure the repeater to the wall. When mounting the
screws to the wall, leave 1/16" (1.6 mm) space between the screw head and the
wall. Using the mounting holes, slide the repeater down on to the screws until it is
firmly seated.
Wall Mount Drilling Template
Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, Motorola recommends that you pre-drill ½-inch
deep pilot holes with a drill bit slightly smaller than the mounting screws before securing the repeater to the surface.
When mounting a repeater on soft surfaces like sheetrock, use an awl to punch holes in the material slightly smaller
than the plastic anchors included in the hardware mounting kit.
The illustration is drawn to a one-to-one scale, which means that it provides the exact dimensions required to mount
the unit.
Drill Holes In
These Positions
3.00 in
1.6 mm (1/16 inch)
maximum